Power Supply - VisionR 800
1. Start-up mode
Position 1: turning on the refraction head by pressing on On/Off with the console.
Position 2: turning on the phoropter head using the ON/OFF switch on the power supply box.
2. Service technician socket
3. Information indicator lights
4. USB port
5. Refraction head connection port (HEAD)
Used for the connection to the phoropter head.
6. USB port
Use this port when updating the CSPola from the VisionR
7. Ethernet port (RJ45)
8. Console connection port (KB)
Used for the connection to the console
9. On/off switch
Network isolation switch.
10. Power cable socket
Related Articles
Power Supply - VisionR 700
Locate each button. 1. Clear Data Short press = Current values reset. Long press = Switch the instrument on/off
Cylinder Power/Axis - VisionR 800
CROSS CYLINDER This test checks the cylinder power, the cylinder axis and the sphere equivalent simultaneously. 1. Cross cylinder test The dots chart is automatically displayed on the screen for the relevant eye. 2. Click Start to begin the test; ...
Head Unit - VisionR 700
Head Unit - VisionR 700
Troubleshooting VisionR 800
During refraction or usage of the device, the keyboard is very slow to react Check the % on the top left corner If it shows less than 40% - Switch the Vision-R system OFF and back ON. Remove fingerprint smudges with a tissue or soft microfiber ...
Adjusting the level - VisionR 800
Follow this recommendation to manipulate the VisionR 800 STEP 1 Introduce the exam to the patient “This device is the Vision-R® 800. This breakthrough device will enable us to measure your refraction at a 0.01 diopter, the highest level of ...